Download ViewSonic PJ1060 Specifications
Transcript
Smart Panel Projector Driver Application Note Viewsonic PJ1060 The hidden functions available for the Viewsonic with this Driver are as follows: MENU ZOOM + ZOOM – FOCUS + FOCUS – ADJ UP ADJ DOWN ADJ LEFT ADJ RIGHT BLANK MUTE RIGHT CLICK LEFT CLICK POSITION TIMER D. Relays 500mA MAX. CURRENT 1 7B 7A 6B 6A 5B 5A SELECTION (EXT. SWITCHER CTRL) 3 2 4B 4 4A 3A 3B PWR OFF MOM. 2B PWR ON MOM. 2A ON Maintained ON Momentary OFF Momentary Momentary; not Binary PWR ON MAINT. 1B Relay 1 Relay 2 Relay 3 Selection RELAYS 1A The following table specifies the factory preset settings for the low-current relays found on the rear of the Smart Panel. The Configuration Utility can be used to customize these settings your installation. E. Other Presets The following table specifies other default factory settings for this Driver that affect is control of the Projector. Power Status Feedback Method Control Wiring RS-232 Polling (see note 1) Infrared Emitter (see note 2) Control for the Viewsonic with this Driver is via both RS-232 and Infrared. The following table specifies settings for the Panel’s configurable timers. For more information on the inactivity shutdown feature and the lockout timer see the Smart Panel Configuration and Installation Guide. Lockout Timer Inactivity Shutdown 80 seconds (see note 3) Disabled © 2003 SP Controls Inc. 601 Minnesota Suite 115, San Francisco, CA 94107 [email protected]