Download ViewSonic PJ1060 Specifications

Transcript
Smart Panel Projector Driver Application Note
Viewsonic PJ1060
The hidden functions available for the Viewsonic with this Driver are as follows:
MENU
ZOOM +
ZOOM –
FOCUS +
FOCUS –
ADJ UP
ADJ DOWN
ADJ LEFT
ADJ RIGHT
BLANK
MUTE
RIGHT CLICK
LEFT CLICK
POSITION
TIMER
D. Relays
500mA MAX. CURRENT
1
7B
7A
6B
6A
5B
5A
SELECTION
(EXT. SWITCHER CTRL)
3
2
4B
4
4A
3A
3B
PWR
OFF
MOM.
2B
PWR
ON
MOM.
2A
ON Maintained
ON Momentary
OFF Momentary
Momentary; not Binary
PWR
ON
MAINT.
1B
Relay 1
Relay 2
Relay 3
Selection
RELAYS
1A
The following table specifies the factory preset
settings for the low-current relays found on the rear
of the Smart Panel. The Configuration Utility can
be used to customize these settings your installation.
E. Other Presets
The following table specifies other default factory settings for this Driver that affect is control of the
Projector.
Power Status Feedback Method
Control Wiring
RS-232 Polling (see note 1)
Infrared Emitter (see note 2)
Control for the Viewsonic with this Driver is via both RS-232 and Infrared.
The following table specifies settings for the Panel’s configurable timers. For more information on the
inactivity shutdown feature and the lockout timer see the Smart Panel Configuration and Installation
Guide.
Lockout Timer
Inactivity Shutdown
80 seconds (see note 3)
Disabled
© 2003 SP Controls Inc. 601 Minnesota Suite 115, San Francisco, CA 94107
[email protected]