Download Dish Network 3 Setup guide

System Setup (Cont.)
(Continued from previous page)
The green LED on the X-PORT LINK connector should be blinking once every two to three
seconds (if video is present on the Ethernet).
8. If applicable, connect the RF output on the upconverter to the combiner.
9. Check one or more room receivers to make sure all content is properly mapped and
available.
Typical
Setup
for a Single HD Program
DISH
NetworkFlow
SatelliteCharts
Signal *
A/V Cables
HCS7720 Connected to External Modulator
(for monitor only) and Upconverter
NTSC
Monitor
RF
Cable
DISH Network Satellite Signal *
Satellite In
A/V Cables
(for monitor only)
ViP 222k
Satellite
Receiver
RF
Cable
Satellite InEthernet
HDMI Out
ViP 222k
Satellite
Receiver
ASI Ethernet
HDMI Out
X-Port Link In
HDMI In
NTSC
Monitor
Service Port
Connection
Laptop
PC
HCS7720
ASI Out
X-Port Link In
HDMI In
Service Port
Connection
Laptop
PC
HCS7720
IF In
ASI In
QAM
or VSB
ASI
Modulator
IF Out
ASI Out
RF
Coaxial
Cable
QAM or VSB
Modulator
Combiner
RF
Distribution
System
RF
Cable
Combiner
RF
Distribution
System
RF Out
IF Out
DTV
Upconverter
RF
Coaxial
Cable
necessary if the number of
transcoders exceeds the dish
antenna’s capacity.
RF
Cable
DTV
Upconverter
IF In
ASI In
* Multi-switch will be
RF Out
HCS7720 Controlled by MUX/MOD Feature Card
DISH Network Satellite Signal *
A/V Cables
(for monitor only)
NTSC
Monitor
RF
Cable
DISH Network Satellite Signal *
Satellite In
RF
Cable
A/V Cables
(for monitor only)
ViP 222k
Satellite
Receiver
Laptop
PC
Satellite In Ethernet
HDMI Out
Service Port
or Ethernet
Connection
ViP 222k
Satellite
Receiver
X-Port Link In
HDMI In
14
HCS7720
* Multi-switch will be
necessary if the number of
transcoders exceeds the dish
antenna’s capacity.
Laptop
PC
X-Port LinkEthernet
In
HDMI In HDMI Out
HCS7720
NTSC
Monitor
Service Port
or Ethernet
Data Bus on
Card Frame
Backplane
Data Bus on
Card Frame
Backplane
Card
MUX/MOD
Connection
Frame
Feature
(Up to 8
Card
Inputs)
RF
Cable
Combiner
RF
Distribution
System
Combiner
RF
Distribution
System
RF Out
Card
MUX/MOD
Frame
Feature
(Up to 8
Card
Inputs)
RF Out
RF
Cable
206-4180