Download COMPRO V150 - START UP GUIDE Operating instructions

Open the fast-closing lock of the reflector (H) by turning
towards the left. Turn the reflector (H) downwards.
Remove the faulty halogen lamp.
Note:
That the reserve lamp is recognized by the <R> marking
on the base. We advise users to insert the reserve lamp in
the main lamp holder and to insert the new halogen lamp
in the reserve lamp holder.
Attention!
When a lamp is replaced, check to see whether there are
over-heated parts in the lamp holders. If there are any overheated parts, inform the client-assistance service.
Screw in the connector for the pull-out hand grip During
this operation check the coding of components to ensure
correct assembly. The plastic rings on the sides of the lamp
and beside the hand grip unit can be connected in only one
position.
Switch on the illumination system and check whether the
lamp lights up. Also make sure the warning lamp is off.
After replacing the faulty halogen lamp turn the reflector
(H) upwards and close again by turning the fast-locking
device towards the right.
CHROMOPHARE® D 650plus, D 530plus,D 300, C 95x Operating instructions (E)
27