Download CJ Spray 710 Technical data

ow:
Tighten all fluid connections securely before eachuse. Handle and route hoses carefully. Do
not pull on
hoses to move equipment.Do not use fluids
or solNever use a damaged hose. Before each use, check
vents which arenot compatible with the
inner tube
the entire hose for cuts, leaks, abrasion, bulging
and cover of the hose.
cover. or damaae or movement of the hose . CouDlinw.
If anyof these conditionsexist, replace the hose
immediately.
FIRE OR EXPLOSION HAZARD
Ignition Sources
.Sparking and Flammable Vapors Hazard
Avoid all ignition sources such
as static electricity
of
in the normal operation
Sparking can be expected
theturbinemotor.Sparkscouldignitefumesfromfromplasticdropcloths,openflamessuchaspilot
as cigarettes, arcs from conflammable liquid, dust particles and other flammable lights, hot objects such
substances in thesprayarea,andcauseseriousnectingordisconnectingpowercordsorturninglight
injury and property damage. Be sureto follow the p r e . switches on and off. Extinguish or remove all sources
cautions
ignition.
of
When flammable liquid issprayed or used for
flushing or cleaning equipment, the turbine must
be placed at least20 feet (6.1 m) away from areas
where hazardous concentrations of flammable
vapors arelikely to occur.
Use additional air hose if necessary to ensure that
the turbine is operated
in a clean, dry, well ventilated area.
Never place the turbine insidea spray booth! Use
this equipment outdoors or in extremely well ventilated areas.
Grounding
To reduce the risk of static sparking, ground the turbine and all other spray equipment used or located in
the spray area. Check yourlocal electrical code for
detailed grounding instructions for your area and type
of equipment.
To ground the turbine: Plugthe power supply cord
into a properly grounded outlet. Do not remove the
grounding prong from the power cord.
Do not use an
adapter. Extension cords must have three wires and
be rated fora minimum of15 amps.
IMPORTANT
United States Government safety standards have been adopted under the Occupational Safety and Health Act. These standards--particularly the General Standards,Part 1910 and the Construction Standards, Part 1926--should be consulted.
Table of Contents
Warnings.. ....................................
Introduction ...................................
Fluid Set Selection Charts .......................
Setup.. .......................................
Shutdown ....................................
SprayingTechniques ..........................
Maintenance.. ................................
Service ......................................
2
4
4
6
11
12
13
16
Troubleshooting.. .............................
18
Parts
20
Model710 ................................
Models 709HS & 71OHS ....................
22
Model 71OP ...............................
24
Accessories ..................................
25
Technical Data ........................
BackCover
BackCover
Warranty .............................
308-336
3