Download VTech Power Zone 2000 Installation guide

[Headset] Battery Charging
After installing the battery, charge the Headset by placing it in the Headset Charger as shown below. Before registration, the
Headset ON/OFF light flashes twice every five seconds whether the Headset is charging or not. After registration, the Headset
ON/OFF light is on when the Headset is charging.
To charge the battery:
1.
Insert the Headset into the Charger as shown in Figure 47.
2.
Push the Headset downward until
the ON/OFF light on the Headset
turns on as shown in Figure 48.
ON/OFF Light
Insert
Figure 48. Headset ON/OFF Light
Figure 47. Insert Headset
Synapse Installation Guide
40
[Headset] TL7600 Cordless Headset Installation