Download Chery V5 User`s manual

Emergency Procedures
order to avoid it affects the
brightness of the bulb. The
lighting
system
is
a
safety
component, please pay more
attention on the replacement of it
and ensure that any detail must be
High-mount stop lamp bulb
The high-mount stop lamp bulb can’t
be replaced. If the bulb fails to work,
please immediately get to the Chery’s
station to have it repaired, if
necessary.
The position lamp bulb can’t be
replaced. If the bulb fails to work,
1.
Turn off the interior lights.
repaired.
2.
Insert the screwdriver into the
6.
license plate.
1.
and take out these screws.
2.
take out the lampshade.
3.
Remove the self-tapping screws
used to fix the license plate lamp,
Replace the bulb, and install the
reflector.
4.
Reinstall the lampshade into the
installation hole located on the
Draw out the holder and take out
lamp housing.
the bulb damaged.
Install it in reverse order.
After installation, check whether
and lampshade, and carefully
Installation position: On the top of
special service station to have it
5.
gap between the lamp housing
License plate lamp bulb
please immediately get to the Chery’s
repaired.
Internal front/rear ceiling
lamp bulb
special service station to have it
proper in case of replacement.
Get to the Chery’s special service
tighten the lamp.
3.
the lamp works normally.
4.
Install the new bulb into the
Sun visor mirror light:
holder, and then install the holder
Installation position：On the rear of sun
well.
visor.
Use the self-tapping screws to
Take out the mirror and then replace
131