Download Enterasys APS-3000 Specifications

Examples
This example enables the ability of the Guest Administrator to set account lifetimes.
EWC.enterasys.com:wlans:Lab126-12-GuestP:auth:captiveportal# set-acct-lifetime
enable
19.6.5.9.16 tos-override
Use the tos‐override command, within context wlan:<WLAN‐service‐name>:auth:captiveportal, to enable or disable external portal integration with Policy Manager (NAC). This command is available when the named WLAN service is in “external” mode.
Syntax
tos-override (enable tos <HH>) | disable
Parameters
enable tos Enables ToS override
<HH>
Specifies a hexidecimal value for ToS override. For the NAC integration, this should be 40 (0x40)
disable
Disables ToS override
Usage
This command is used to configure an external portal integration with NAC where HTTP traffic for non authenticated users is tagged with a ToS override value. To integrate with NAC, you must use this command to set the hexidecimal ToS override value on the controller to 0x40. The external authentication mode must be set for this command to be available. For more information, see “mode” on page 19‐32.
Examples
The following example enables ToS override with the hex value required for NAC integration (0x40):
EWC.enterasys.com:wlans:new-wlans:auth:captiveportal# tos-override enable tos 40
EWC.enterasys.com:wlans:new-wlans:auth:captiveportal# apply
EWC.enterasys.com:wlans:new-wlans:auth:captiveportal# show tos-override
ToS override for NAC Value(Hex):0x40
Note: After you run the tos-override command, you must run the apply command to implement the
changes.
19.6.5.10 cdr
Use the cdr command to enable or disable the collection of Wireless Controller accounting information. The cdr command is accessible from the wlan:<WLAN‐service‐name>:auth context of the CLI.
Syntax
cdr enable | disable
Enterasys Wireless Controller Software CLI Reference Guide
19-27