Download Model Tech Mini Mach Racer Specifications

Transcript
TOOLS AND SUPPLIES REQUIRED
q 5 Minute Epoxy
q 220 Grit Sandpaper
q Thin and Thick C/A
q Sanding Block
q C/A Debonder
q Masking Tape
q Formula 560 Canopy Glue
q Paper Towels
q # 1 and # 2 Phillips Head Screwdrivers
q Rubbing Alcohol
q Wire Cutters
q Epoxy Mixing Sticks
q Needle Nose Pliers
q Epoxy Mixing Cups
q Modeling Knife
q Soldering Iron
q Scissors
q Solder
q Electric or Hand Drill
q Heat-Shrink Tubing (Assorted Sizes)
q Assorted Drill Bits
q Heat Gun (for Heat-Shrink Tubing)
q Straight Edge Ruler
q Heat Sealing Iron (for Covering Material)
q Pencil
q White Covering Material 1/2" x 24" (1.3cm x 61cm)
q Builder's Triangle
KIT CONTENTS
Before you begin assembly, group the parts as we list them below. This will ensure that you have all of the parts before you begin assembly
and it will also help you become familiar with each part.
If you find any parts missing or damaged, please contact your local model tech
dealer directly, using the separate Customer service sheet included with your kit.
AIRFRAME ASSEMBLIES
q (1) Wing with Hatch Cover
q (1) Right Elevon
q (1) Left Elevon
q (2) Vertical Stabilisers
CONTROL SYSTEM ASSEMBLIES
q (2) 5-3/4" (146mm) Threaded Wires with Z-Bends
q (2) Nylon Control Horns with Backplates
q (2) Nylon Clevises
q (6) M2 x 16mm Machine Screws
q (6) C/A-Style Hinges
MISCELLANEOUS PARTS
q (1) Cowling
q (1) Canopy
q (1) Landing Skid
q (2) Plywood Spacer Plates
q (1) Hook and Loop Material
q (4) M3 x 12mm Machine Screws
q (4) M3 x 18mm Machine Screws
q (4) M3 Flat Washers
q (4) M2 x 10mm Washer-Head Wood Screws
q (1) Decal Sheet (Not Pictured)
Page