Download Agilent Technologies E4438C Installation guide
Transcript
Operation Verification I/Q Modulation Check I/Q Modulation Check 1. Press Preset. 2. Press I/Q > I/Q Calibration > Calibration Type User Full until Full is highlighted. 3. Press Execute Cal to begin an I/Q calibration of the full frequency range of the signal generator. The message I/Q Calibration in Progress is displayed until the calibration is complete. To abort the I/Q calibration, press Abort Cal. The message I/Q Calibration in Progress Aborting... is displayed until the calibration is stopped completely. NOTE Chapter 3 The I/Q calibration is stored in non-volatile memory and remains unchanged during a preset or the power cycle of the signal generator. 33