Download Cisco Cisco Wireless LAN Controller 4100 User guide
Transcript
Chapter 3 WLANs Menu Bar Selection WLANs Table 3-2 General Policies (continued) Parameter Description 7920 Phone Support Select one of the following: • Disabled—Use this setting to disable support for your Cisco 7920 phones on the WLAN. • Client CAC Limit—Use this setting if you want the WLAN to support the older version of the software on your Cisco 7920 phones. In older versions, the CAC limit is set on the client. • AP CAC Limit—Use this setting if you want the WLAN to support the newer version of the software on your Cisco 7920 phones. In newer versions, the CAC limit is advertised by the access points. • All 7920 Phones—Use this setting to enable WLAN support for all Cisco 7920 phones. Broadcast SSID Enable or Disable the Service Set Identifier broadcasts. Allow AAA Override Enable or disable AAA override for global WLAN parameters. When AAA Override is enabled, and a client has conflicting AAA and controller WLAN authentication parameters, client authentication is performed by the AAA server. As part of this authentication, the Operating System will move clients from the default Cisco WLAN Solution WLAN VLAN to a VLAN returned by the AAA server and predefined in the controller Interface configuration (only when configured for MAC filtering, 802.1X, and/or WPA operation). In all cases, the Operating System also uses QoS, DSCP, 802.1p priority tag values and ACLs provided by the AAA server, as long as they are predefined in the controller Interface configuration. (This VLAN switching by AAA Override is also referred to as Identity Networking.) For instance, if the Corporate WLAN primarily uses a Management Interface assigned to VLAN 2, and if AAA Override returns a redirect to VLAN 100, the Operating System redirects all client transmissions to VLAN 100, regardless of the physical port to which VLAN 100 is assigned. When AAA Override is disabled, all client authentication defaults to the controller authentication parameter settings, and authentication is only performed by the AAA server if the controller WLAN do not contain any client-specific authentication parameters. The AAA override values may come from a RADIUS server, for example. External Policy Validation External security policy validation. Enable or Disable. Client Exclusion When automatic adding to the Exclusion List (disabling) is enabled, set the timeout in seconds for disabled client machines. Client machines are disabled by MAC address and their status can be observed on the Clients > Detail page. A timeout setting of 0 indicates that administrative control is required to re-enable the client. Cisco WLAN Controller Web Interface User Guide 3-4 OL-7416-04