Download VES Switch

Chapter 76 VLAN Commands
76.3 Command Summary
The following section lists the commands for this feature.
Table 182 vlan Command Summary
COMMAND
DESCRIPTION
M
P
show vlan
Displays the status of all VLANs.
E
13
show vlan <vlan-id>
Displays the status of the specified VLAN.
E
13
show vlan counters <vlan-id>
<port-number> <Tx|Rx>
Displays concurrent incoming or outgoing packet statistics of
the specified port in the specified VLAN and refreshes in
every 10 seconds until you press the [ESC] button.
E
13
vlan-type <802.1q|port-based>
Specifies the VLAN type.
C
13
vlan <vlan-id>
Enters config-vlan mode for the specified VLAN. Creates the
VLAN, if necessary.
C
13
fixed <port-list>
Specifies the port(s) to be a permanent member of this VLAN
group.
C
13
no fixed <port-list>
Sets fixed port(s) to normal port(s).
C
13
forbidden <port-list>
Specifies the port(s) you want to prohibit from joining this
VLAN group.
C
13
no forbidden <port-list>
Sets forbidden port(s) to normal port(s).
C
13
inactive
Disables the specified VLAN.
C
13
no inactive
Enables the specified VLAN.
C
13
name <name-str>
Specifies a name for identification purposes.
<name-str>: 1-64 English keyboard characters
C
13
normal <port-list>
Specifies the port(s) to dynamically join this VLAN group
using GVRP
C
13
untagged <port-list>
Specifies the port(s) you don’t want to tag all outgoing frames
transmitted with this VLAN Group ID.
C
13
no untagged <port-list>
Specifies the port(s) you want to tag all outgoing frames
transmitted with this VLAN Group ID.
C
13
isolation
Allows each port (in the specified VLAN) to communicate only
with the CPU management port and the Gigabit uplink ports
but not communicate with each other.
C
13
no isolation
Disables port isolation on the specified VLAN.
C
13
protovlan
Enables this protocol based VLAN.
C
13
no protovlan
Disables this protocol based VLAN.
C
13
limitMAC <numbers>
Limits the the number of (dynamic) MAC addresses learned
in the same VLAN.
numbers: 1~4000 or 1~16384. This may vary depending on
the device model.
C
13
help
Provides more information about the specified command.
C
13
ip address <ip-address>
<mask> [manageable]
Sets the IP address and subnet mask of the Switch in the
specified VLAN.
manageable: add this option to have the Switch allow not
only ICMP but also FTP, HTTP, SNMP and Telnet access to
the IP address for management purposes. Without adding
this, the Switch denies management traffic except ICMP
packets accessing the IP address.
C
13
298
VES Switch CLI Reference Guide