Download Mitel 8500 Installation guide

5 Specify a Service Feature Restriction Class (SFC) for the voice messaging
ports, see the ASFC command. It is recommended that all voice messaging
ports be placed in their own SFC. The following Service Feature Indexes (SFIs)
are needed in the SFC:
SFI
Service feature
10
Call hold
103
Assignment of no answer timer for blind transfer
to station or blind transfer to attendant
104
Blind transfer
6 Assign all of the voice messaging ports to a Uniform Call Distribution (UCD)
group using ASHU command.
NOTE
If the phone system that hosts the voice messaging ports
extensions is part of a NEC Fusion network and those ports need
to be accessible from the other Fusion nodes, then the UCD must
be configured to contain the logical numbers corresponding with
the ports extensions, see the ALGSN, ASHUN commands.
CAUTION
Do not use a phantom single line extension for the UCD pilot
number.
7 Complete programming the phone system. See “To complete programming
the phone system” on page 252.
To program the IP Terminal ports
1 Make sure that the SV8500 system has enough IP licenses using the DPTR
command.
2 Configure the voice messaging ports as IP Terminal extensions using the
AISTL command, KIND=IP DTERM, TEC = 12.
3 Make sure the phone system is using the Protected Login Mode for the voice
mail IP ports registration and set the password of each port to be the same
with the port extension.
4 Specify a Service Feature Restriction Class (SFC) for the voice messaging
ports, see the ASFC command. It is recommended that all voice messaging
ports be placed in their own SFC. The following Service Feature Indexes (SFIs)
are needed in the SFC:
SFI
Service feature
10
Call hold
103
Assignment of no answer timer for blind transfer
to station or blind transfer to attendant
104
Blind transfer
5 Assign all of the voice messaging ports to a Uniform Call Distribution (UCD)
group (see command ASHU).
NOTES
●
●
Logical numbers appear only in a NEC Fusion network and are used
to uniquely identify all the extensions in the network.
If the phone system that hosts the voice messaging ports extensions
is part of a NEC Fusion network and those ports need to be accessible
from the other Fusion nodes, then the UCD must be configured to
contain the logical numbers corresponding with the ports extensions,
see the commands ALGSN, ASHUN.
NEC UNIVERGE SV8500 WITH LAN MCI
251