Download Renault 2009 CLIO Specifications

BATTERY
Battery: Removal - Refitting
a Torque tighten the positive battery terminal nut (6
N.m).
80A
III - FINAL OPERATION
a Clip:
- the small part of the battery housing,
WARNING
- the large part of the battery housing.
Poor contact may cause starting or charging
faults, create sparks and cause the battery to
explode.
K4J or K4M or M4R
(see 80A, Battery, Battery: Precautions for the
repair, page 80A-4) .
2 - REFITTING
a Fit the battery into its housing, placing it as close as
possible to the engine side.
a Refit the battery bracket.
a Refit the air resonator.
a When refitting the battery or each time it is disconnected, carry out a certain number of operations,
without using the diagnostic tool, so that the vehicle
can operate correctly (see Battery: Initialisation)
(80A, Battery).
a Tighten to torque the battery bracket nut (12 N.m).
a Connect the degassing pipe to the battery.
a Connect the protective fuse holder to the positive
battery terminal.
a Position the charge terminal on the positive terminal
studs.
a Fit the protective fuse holder against the battery heat
shield while securing.
a Torque tighten the fuse holder nuts (6 N.m).
WARNING
Poor contact may cause starting or charging
faults, create sparks and cause the battery to
explode.
(see 80A, Battery, Battery: Precautions for the
repair, page 80A-4)
3 - CONNECTION
a Loosen the negative battery terminal.
a Push the negative battery terminal fully onto the battery terminal post.
a Torque tighten the negative battery terminal nut (6
N.m).
WARNING
Poor contact may cause starting or charging
faults, create sparks and cause the battery to
explode.
(see 80A, Battery, Battery: Precautions for the
repair, page 80A-4) .
80A-3