Download ADTRAN 624 Specifications

Section 4.2 T1 TDM UIG
Total Access 600 Series System Manual
L2 PROTOCOL (ETH[1])
Configure the L2 PROTOCOL parameters and view the status of the Ethernet interface from this menu.
The 1 in ETH[1] represents a physical port. The Ethernet physical port is always 1.
L2 PROTOCOL (ETH[1]) > PROTOCOL
Displays the L2 protocol for the 10/100BASET Ethernet port. Currently only 802.3 is supported.
L2 PROTOCOL (ETH[1]) > CONFIG
Configure the mode for this 10/100BASET Ethernet port from this menu.
L2 PROTOCOL (ETH[1]) > CONFIG > MODE
The mode identifies how the data will be forwarded. The choices are;
ROUTE IP
All IP data will be routed
BRIDGE ALL
All data will be bridged
ROUTE IP/BRIDGE OTHER All IP data will be routed. All other data will be bridged.
The default is ROUTE IP.
L2 PROTOCOL (ETH[1]) > STATUS
View the L2 protocol statistics for the 10/100BaseT Ethernet port from this menu.
L2 PROTOCOL (ETH[1]) > STATUS > TX PACKETS
Total number of packets transmitted out the Ethernet port.
L2 PROTOCOL (ETH[1]) > STATUS > RX PACKETS
Total number of packets received from the Ethernet port.
L2 PROTOCOL (ETH[1]) > STATUS > TX ERRORS
Total number of transmit errors encountered on Ethernet port.
L2 PROTOCOL (ETH[1]) > STATUS > SINGLE COLLISIONS
Total number of single collisions before successful transmission.
100
© 2002 ADTRAN, Inc.
61200624L1-1A