Download Adaptec 2120S - SCSI RAID Controller User`s guide

container Commands
container unmirror
To unmirror a mirror set, resulting in a single-partition volume set
and freespace, use the container unmirror command. Note
that there is no equivalent command for a multilevel array of mirror
sets. To unmirror a multilevel array of mirror sets, use this
command for each underlying mirror set.
Syntax
container unmirror {container}
Parameters
{container}
Specifies the ID number (0 to 63) of the mirror set to unmirror.
You previously created the mirror set by using the container
create mirror or container create mmirror
command.
Examples
Before unmirroring a mirror set, use the container list
command to obtain information about any existing arrays. As the
following example shows, there is one existing array (array 0, a
mirror set) on this controller at the time the mirror set is unmirrored:
AAC0>container list
Executing: container list
Num
Total Oth Stripe
Scsi
Dr Label Type
Size
Ctr Size
Usage
C:ID:L
-- ----- ------ ------ --- ------ ------- -------0
Mirror 10.0MB
NTFS
0:02:0
0:03:0
State
----Normal
Note that the example eliminates some items in the container
list display so that you can see an example of the State column.
5-123