Download Extron electronics SW4 DVI Plus User guide

Furniture Mounting (SW2 and SW4 DVI Plus Only)
To mount an SW2 or SW4 DVI Plus switcher under a desk, table, or podium, use the optional
MBU 123 Mini Under-Desk Mounting Kit (part number 70-212-01) as follows:
1. If rubber feet were previously attached to the bottom of the unit, remove them.
2. Remove the two screws from each side of the switcher. Retain the screws for possible
later reassembly.
3. Attach the brackets to the sides of the unit, using the provided machine screws.
Figure 38.Preparing the SW2 or SW4 DVI Plus Switcher for Under-furniture
Mounting
4. Hold the unit with the attached brackets against the underside of the table or other
furniture. On the mounting surface, mark the location of the screw holes for each
bracket.
5. Drill 3/32 inch (2 mm) diameter pilot holes, 1/4 inch (6.3 mm) deep, into the mounting
surface at the marked screw locations.
6. Insert #8 wood screws into the four pilot holes. Tighten each screw into the mounting
surface until slightly less than 1/4 inch of the screw head protrudes.
7. Align the centers of the slots in the brackets with the mounting screws and place the
unit against the surface, with the screw heads through the bracket slots.
8. Slide the unit slightly forward or back, then tighten all four screws to secure it in place.
SW DVI Plus Series • Reference Information
38