Download CME GPP-3 Specifications

Transcript
AT command set for XX Siemens mobile phones and modems
+CMGS: <mr>
If sending is not successful:
+CMS ERROR
Parameter:
Length of PDU
The PDU begins with the service-center address
(according to GSM 04.11, [9]), followed by the TPDU
(according to GSM 03.40, [6]) in hexadecimal format
Message reference
RP-ACK PDU according to GSM 03.40 [6]
<length>
<pdu>
<mr>
<ackpdu>
AT+CMGW
AT+CMGW
Write an SMS to the SMS memory
Test command
Response:
AT+CMGW=?
OK/ERROR/+CME ERROR
Write command
If PDU mode (+CMGF=0)
AT+CMGW=<length>[,<stat>]<CR>
PDU is given:
<ctrl-Z/ESC>
Response:
+CMGW: <index>
+CMS ERROR
Parameter:
Length of PDU
<length>
<stat>
0 REC UNREAD
i.e. received messages unread (default)
1 REC READ
i.e. received messages read
2 STO UNSENT
i.e. stored unsent messages
3 STO SENT
i.e. stored sent messages
4 ALL
i.e. all messages
The PDU begins with the service-center address
(according to GSM 04.11, [9]), followed by the TPDU
(according to GSM 03.40, [6]) in hexadecimal format
Index of message in selected memory <mem1>
<pdu>
<index>
AT+CMMS
AT+CMMS
More (Short) Message to Send
Test command
Response:
AT+CMMS=?
+CMMS: (list of supported <mode>s)
Parameter:
Disable
Keep link enabled until time between last send messages
command response and next send command exceeds 5
seconds then ME closes the link and TA switches <n> to
0
2
keep link enabled until time between last send messages
__________________________________________________________________________________________
<mode>
0
1
Document No.:
Revision:
Revision Date:
71
A30880-A10-A001-XXD376
Master R75
29. September.2004