Download Extron electronics DMS 3600 Setup guide

5. Align the flanges on the power supply module with the left and
right power supply guides.
3. Gently pull on the screws to loosen the fan from the backplane.
4. Slide the fan out of the chassis.
6. Gently slide the power supply module into the enclosure until the
power supply meets resistance.
5. Orient the fan to be installed so that the printing on the back of
the panel is right-side up.
7. Gently seat the power supply in the backplane.
6. Align the flanges on the fan with the top and bottom fan guides.
8. Tighten the left and right knurled knobs to lock the power supply
in place. Use a screwdriver to tighten the knurled knobs.
7. Gently slide the fan into the enclosure until the fan meets
resistance.
8. Gently seat the fan in the backplane.
Removing and Installing a Fan
9. Tighten the top and bottom knurled knobs to lock the fan in
place. Use a screwdriver to tighten the knurled knobs.
The DMS 1600 has a single fan module. The DMS 3600 has two
identical fan modules. The fan modules are hot-swappable. If a fan
fails, it should be replaced at the earliest opportunity.
NOTE:
10.Secure the row identification plate to the fan.
The fans modules are hot-swappable. Either fan can
be removed or installed without powering down the
switcher.
1. Remove and retain the two screws that secure the row
identification plate (identifying the rows of the adjacent DVI input
and output connectors) to the fan. Retain the plate.
2. Rotate the top and bottom knurled knobs to completely loosen
the captive screws (see figure 15).
D
I
S 44
DV
DM
S
C
UT
TP
I-D
D
OU
I
DV
S 44
DV
DM
B
S
C
UT
TP
I-D
D
OU
I
DV
S 44
B
S
C
UT
TP
I-D
D
OU
I
DV
D
S 44
B
S
C
UT
TP
I-D
D
IN
DV
DM
A
OU
LY
DV
C
TS
PU
I-D
DV
DM
A
PP
A
WER
B
SU
T PO
DV
AN
ND
DU
RE
B
C
TS
D
PU
I-D
IN
A
DV
A
B
C
TS
D
PU
I-D
IN
DV
A
B
C
TS
PU
I-D
LY
IN
PP
DV
WER
A
SU
Y PO
AR
B
IM
PR
A
X.
A MA
1.2
REDUNDANT
Hz
/60
V
50
40
0-2
PRIMARY
RESET
DISCONNECT BOTH POWER
CORDS BEFORE SERVICING
X.
A MA
Hz
1.2
/60
V
50
40
0-2
H
ITC E
SW NC
RE
FE
10
RE
1-8
Align the fan
module edges with
the plastic guides.
, CA
EIM
AH
25 - 32
17 - 24
AN
9 - 16
REMOTE
LINK
LAN
ACT
TRI-LEVEL BI-LEVEL
RS-232/RS-422
10
Knurled
Knobs
Figure 15. Remove and Install a Fan
28
DMS 1600 and DMS 3600 • Maintenance and Modifications
DMS 1600 and DMS 3600 • Maintenance and Modifications
29