1
Download Motorola WiNG 5.2.6 Specifications
Transcript
USER EXEC MODE COMMANDS
2-9
2.1.3 clear
user exec mode commands
Clears parameters, cache entries, table entries, and other similar entries. The clear command is available for specific
commands only. The information cleared using this command varies depending on the mode where the clear command is
executed.
Supported in the following platforms:
• Access Points — AP300, AP621, AP622, AP650, AP6511, AP6521, AP6532, AP71XX, AP81XX
• Wireless Controllers — RFS4000, RFS6000, RFS7000, NX9000, NX9500
NOTE: Refer to the interface details below when using clear
• ge <index> – RFS4000 supports 5GEs and RFS6000 supports 8 GEs
• me1 – Available in both RFS7000 and RFS6000-up1- Uplink interface on RFS4000
Syntax
clear [arp-cache|cdp|crypto|event-history|ip|lldp|spanning-tree]
clear arp-cache {on <DEVICE-NAME>}
clear [cdp|lldp] neighbors {on <DEVICE-NAME>}
clear crypto [ipsec|isakmp] sa [<IP>|all] {on <DEVICE-NAME>}
clear event-history
clear ip dhcp bindings [<IP>|all] {on <DEVICE-NAME>}
clear spanning-tree detected-protocols {interface|on}
clear spanning-tree detected-protocols {on <DEVICE-NAME>}
clear spanning-tree detected-protocols {interface [<INTERFACE>|ge <1-4>|me1|
port-channel <1-2>|vlan <1-4094>]} {on <DEVICE-NAME>}}
Parameters
• clear arp-cache {on <DEVICE-NAME>}
arp-cache
Clears Address Resolution Protocol (ARP) cache entries on an AP or wireless controller.
This protocol matches the layer 3 IP addresses to the layer 2 MAC addresses.
on <DEVICE-NAME>
Optional. Clears ARP cache entries on a specified AP or wireless controller
• <DEVICE-NAME> – Specify the name of the AP or wireless controller.
• clear [cdp|lldp] neighbors {on <DEVICE-NAME>}
cdp
Clears Cisco Discovery Protocol (CDP) table entries
lldp
Clears Link Layer Discovery Protocol (LLDP) table entries
neighbors
Clears CDP or LLDP neighbor table entries based on the option selected in the preceding
step
on <DEVICE-NAME>
Optional. Clears CDP or LLDP neighbor table entries on a specified AP or wireless
controller
• <DEVICE-NAME> – Specify the name of the AP or wireless controller.
