Download Code Alarm 4000 System information

7.53.
Enable "Call Central Station" display
Informs the Central Station in the event of opening or closing faults. In case of a burglar
alarm or tamper activation and when the “delay reporting alarms” timer has expired, the
user will be informed after disarming by the text “Call Central Station” on the LCD if the
reporting to the Central Station was successful. This displayed message “Call Central
Station” shall only be displayed for 30 seconds, and is only displayed on RAS’s linked to
the AREA or AREAs that went into Alarm. The user can decide to call the Central Station
to inform the status i.e. on opening or closing faults.
Exceptions:
This text will not appear after reporting PANIC, HOLD-UP Alarms (HA) reports or
disarming by a Duress PIN-code. Also when a LINE FAULT is concurrently active, this
text will not appear.
7.54.
Scandinavian Options
YES – Scandinavian Indicators
*-Change 0-Skip
Allows the user to enable or disable the Scandinavian Indicators.
YES
Scandinavian Indicators option will be enabled.
NO
Scandinavian Indicators option will not be enabled.
YES – Enable Log Limitations
*-Change 0-Skip
7.55.
Enable Log Limitations
Limits the number of times an input can log and report a change of state event within the
same arm/disarm cycle. A limit of three (3) times has been set.
Input types excluded from log limitations are as follows:
6, 7, 9, 12, 16, 18, 19, 20, 23 to 27, 31, 32, 34 to 39, 57, 58, 65.
These types are generally associated with access control, or have a special function, and
are not associated with the normal alarm functionality.
YES – Indicate Inhibited Zones
*-Change 0-Skip
7.56.
Indicate Inhibited Zones
Alerts the system user at the RAS with an optical and audible indication that zones are
inhibited in an area that is being armed. The inhibited zones need to be listed and the
user prompted with the option whether to arm the system or not.
80
ATS2000/3000/4000/4500 Programming manual