Download CommandCNC+DTHCIV-Pa..

NEW FEAURES FOR SHEETCAM POST
What this POST provides:
 Correct G-Code syntax for LINUXCNC (CommandCNC) systems
 The option to run with TAP (Total Automatic Plasmas for use with Hypertherm
RS485 option and HyT-Connect RS485 option’
 The option to use a plasma “drill” tool to center mark (peck start) drill holes
(gouge
 Has “Set Custom Post Options” for Ref Distance; Switch Offset
 Minimum Cut Length setting keeps DTHC OFF for short cuts and small circles
 Supports SheetCAM Job (global) and Operation level Cut Rules like corner
slowdown, and DTHC off before end of cut.
 Supports SOFT PIERCE on Hypertherm’s with RS485 (Cut Current remote set)
including during a “peck start”

CandCNC
PAGE 51