Download PC and PS2 Error Code List - IBM

IBM PC and PS/2 - Error codes
24 of 54
http://ps-2.kev009.com/pcpartnerinfo/ctstips/49fe.htm
If it's definitely on the planar (ie another monitor fails) check the Inmos
palette DAC (ceramic DIP module with gold colored middle) for shorts between
the pins.
2402 (PS/2) Diagnostic video error
2408 (PS/2) VGA Ground Circuit Fault -- cord may be disconnected at system end
2409 (PS/2) VGA Ground Circuit Fault -- may be related to 8602 error
FIRST, check that you have DASDDRVR in config.sys. Then replace display; if
failure repeats during video diagnostics, replace the system board.
2410 (PS/2) Replace System Board
2601-2655 XT/370-M CARD P-Processor
2657-2668 XT/370-M CARD M-Memory
2672 XT/370-M CARD EM-Emulator
2673-2674 XT/370-P CARD
2677-2680 XT/370-P CARD
2681 XT/370-M CARD
2682-2694 XT/370-P CARD
2697 XT/370-P CARD
2698 DIAGNOSTIC DISKETTE ERROR
2701-2703 XT/370-EM CARD
2801 3278/79 Emulation DFCA Card -- Unplug coax before running diagnostics
2801 (PS/2) 3270 Adapter keystroke accepted status bit failure
2802 (PS/2) Reset decoded status bit failure
2803 (PS/2) Cursor low reg incorrect on reset
2804 (PS/2) Cursor high reg incorrect on reset
2805 (PS/2) RAM buffer ripple pattern incorrect on reset
2806 (PS/2) No por status on poll after reset
2807 (PS/2) Status not clear on poll ack
2808 (PS/2) Terminal id reg write/read test failed
2809 (PS/2) Not busy status bit not working
2810 (PS/2) Address counter low incorrect
2811 (PS/2) Cursor low reg incorrect
2812 (PS/2) Address counter high incorrect
2813 (PS/2) Cursor high reg incorrect
2814 (PS/2) Buffer being modified bit off during write command
2815 (PS/2) Base buffer modified complete not set by write command
2816 (PS/2) Write command/read command results not comparing
2817 (PS/2) Buffer being modified off during clear command
2818 (PS/2) Base buffer modified complete not set by clear command
2819 (PS/2) No op complete status after clear command
2820 (PS/2) Wrong area cleared by clear command
2821 (PS/2) Correct area not cleared by clear command
2822 (PS/2) Correct area not cleared by clear command
2823 (PS/2) Stopping address not correct after clear command
2824 (PS/2) Stopping address not correct after clear command
2825 (PS/2) Correct area not cleared by clear command
2826 (PS/2) Wrong area cleared by clear command
2827 (PS/2) Stopping address not correct after clear command
2828 (PS/2) Stopping address not correct after clear command
9/7/2013 10:30 PM