Transcript
K-3161 POISETM UNDER-MOUNT BAR SINK Roughing-In Installation Notes Product Information Install this product according to the installation guide. Applicable product: Under-mount bar sink - with cutting board and bottom bowl rack Under-mount bar sink - with mirror finished rim, cutting board, and bottom bowl rack K-3161 K-3161-H shown Allow a minimum of 3″ (76 mm) clearance around the sink rim for clip attachment. shown Will comply with ADA when installed per Section 606 Lavatories and Sinks of the 2010 ADA Standards for Accessible Design. Fixture conforms to ASME Standard A112.19.3/CSA B45.4. All dimensions are nominal. Fixture*: Bowl area 14″ (356 mm) x 14″ (356 mm) Water depth 9-3/16″ (233 mm) Drain hole Ø 3-5/8″ (92 mm) *Approximate measurements for comparison only. Included components: Hardware kit Cutout template Sink BambooTM cutting board Bottom bowl rack 91915 1022021-7 K-3391 K-3140 K-3142 2" (51 mm) Countertop 9" (229 mm) 18" (457 mm) Sink Clip 9" (229 mm) 18" (457 mm) 3" (76 mm) Min 1-5/16" (33 mm) 9-1/2" (241 mm) 14-7/8" (378 mm) 1-1/2" OD POISETM UNDER-MOUNT BAR SINK 1022021-1-D