Download HP NetServer E 200 Getting Started Guide

3 Installing Replica
This chapter provides instructions for installing Stac Replica drivers and software
under Windows NT or NetWare. Review the section that applies to the operating
system running on your HP NetServer before starting the Replica installation.
Installing Replica for Windows NT
This section provides instructions for installing Replica and its related files on an
HP NetServer running Windows NT. If you are installing Replica on an HP
NetServer running NetWare, skip to the "Installing Replica for NetWare" section
later in this chapter.
NOTE
For best results, always close any applications running on the
HP NetServer before starting the Replica installation.
What You Need
Before you can install Replica and begin backing up server files, you need the
following:
• An HP NetServer running Windows NT Server 3.51, Windows NT
Server 4.0, or Microsoft Small Business Server
• At least 32 MB RAM
• At least 8 MB free disk space on the boot drive, or on the drive that
contains the system folder
• At least one configured HP SureStore T20 tape drive and a blank tape
cartridge (provided with your server)
• A system console connected to the network and running the TCP/IP or
IPX/SPX communications protocol, which allows the Replica service to
communicate with the Windows application
• Administrator privileges for server access
5