Transcript
EMERGENCY CALL SWITCH Model CA17 EMERGENCY CALL SWITCH Model CA17 The Bogen Model CA17 Call Switch is a momentary-push switch designed for use with PI/SI35A Intercom Systems in conjunction with the SCR25A. When pushed and released once, a signal is sent to the MCP35A via the SCR25A call-in module to annunciate the call-in on the SBA225.The room must be equipped with a 25-volt speaker. The Bogen Model CA17 Call Switch is a momentary-push switch designed for use with PI/SI35A Intercom Systems in conjunction with the SCR25A. When pushed and released once, a signal is sent to the MCP35A via the SCR25A call-in module to annunciate the call-in on the SBA225.The room must be equipped with a 25-volt speaker. The CA17 is designed for flush-mounting in a standard single-gang outlet box; connections are made as illustrated in the figure below. The CA17 is designed for flush-mounting in a standard single-gang outlet box; connections are made as illustrated in the figure below. From MCP35A +12V Terminal. Connect only the +12V Terminal to this point. Do not connect a ground lead to this point. Use second pin to jump +12V DC to additional SCR25A panels. Model CA17 Connecting Diagram Printed in U.S.A. 0301 © 2003 Bogen Communications, Inc. 54-5919-01R3 Specifications subject to change without notice. 50 Spring Street, Ramsey, NJ 07446 U.S.A. 201-934-8500; FAX: 201-934-9832 www.bogen.com From MCP35A +12V Terminal. Connect only the +12V Terminal to this point. Do not connect a ground lead to this point. Use second pin to jump +12V DC to additional SCR25A panels. Model CA17 Connecting Diagram Printed in U.S.A. 0301 © 2003 Bogen Communications, Inc. 54-5919-01R3 Specifications subject to change without notice. 50 Spring Street, Ramsey, NJ 07446 U.S.A. 201-934-8500; FAX: 201-934-9832 www.bogen.com