Transcript
Technical Specifications SPACEDEC DISPLAY POS Multi Dimensions NOTE: This product has been designed to mount 12”(30cm) - 24”(61cm) displays. It will suit VESA compliant displays with 75mmx75mm (3”x3”) & 100mmx100mm (4”x4”) hole patterns only. It will support displays up to a maximum weight of 11kg (24.2lbs). The back to back will support 2 x 11kg (24.2lbs) displays. OD Ø50.8mm (2”) 150mm (5 7/8”) 96mm (3¾”) Cable Access Hole 37mm x 43mm (17/16” x 111/16”) NOTE: If cable access through the post and work surface is required, you will need to drill a Ø45mm cable access hole. (Refer to Installation Instructions.) 375mm (14¾”) Mounting Plate Footprint 84mm 3 5/16” 330mm (13”) 370mm (14 9/16”) Back to Back Mount 244mm (9½”) 190mm (7½”) M4 Tapped Holes 70.7mm 213/16” ID Ø46mm (113/16”) Install Security Cable around Internal Post Ø106mm (4 3/16”) Rotation Your POS Multi offers 355° of Rotation. This can also be limited to suit a specific application. The Direction in which you mount POS Multi will determine where the 5° gap in Rotation is located, and how you choose to limit the rotation. Rotation Options 0° Rotation (Fixed) 0-90° Rotation 0-180° Rotation 0-270° Rotation 0-355° Rotation Locking Holes Direction Arrow 5° Gap in Rotation or 5° Gap in Rotation 355° 180° 270° 0° USER Direction Arrow 0° Locking Hole (Fixed) 0-90° Locking Hole 0-180° Locking Hole 180° 90° 355° (Refer to Installation Instructions for further details) 270° 0° 90° Direction Arrow USER Ball Assembly Each Ball Assembly has 40 degrees rotation about it’s central axis. ±40° Rotation about central axis. 0-270° Locking Hole No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty Ltd. Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published: 01.02.08 © TM