Download Dishwasher Training Program

/
/
5
/
Part # 1 -- Water Valve (1)
Disassembly
The water valve is accessed from the front of the
dishwasher base by removing the toe kick.
To remove water valve:
#
Remove two (2) T-20 Torx screws from toe kick and tilt toe kick
out from under dishwasher.
#
#
Remove base insulation (on models with insulation).
Move sump inlet hose away from water valve (without
disconnecting it).
#
#
#
Disconnect wires from water valve, including ground wire.
Remove two (2) T-20 Torx screws from water valve.
Pull valve out from dishwasher and disconnect water hose from
rear of valve. Remove any water from sump & base.
Removing toe kick
Moving sump hose
CONNECTION HINTS: Water
connection 3/8” NPT female.
Inlet water pressure range 5 120 psi (0.3 – 8.27 bars).
Removing hose clamp
2nd Edition/Revision 3 (3/4/04)