Download Dishwasher Training Program

/
64
/
/
Part # 4 -- Heater & NTC (6)
Removing & Installing NTC:
# Remove heater assembly -- NTC is located on top of
heater assembly.
# Disconnect wires after noting connections (since NTC
& Hi-Limit are included in the same part -- # 165281).
# Remove NTC cover, pull NTC holding tabs apart and
pull NTC out of heater.
NOTE:
Softer bearing & non-softer
bearing heater assemblies, circulation
pumps and sumps cannot be mixed and
matched. Softer bearing heaters don’t fit
in older models and older heaters don’t fit
in softer bearing models.
Hi-Limit
NTC
Disconnect wires
NOTE: To remove flow
switch,
carefully
pry
housing away from switch
(until tabs clear switch),
then snap switch out.
Remove cover & pull tabs
Remove NTC
NTC w/ Hi-Limit
HINT: If needed, use rinse-aid to
lubricate gaskets to make it easier to
assemble heater to sump and pump.
2nd Edition/Revision 3 (3/4/04)