Download GW6600 User Manual

18: Automatic operator selection
_______________________________________________________________________________________________________
In the Exclusive Group field type in 3g.
From the dropdown menu, select the Choose Minimum ifup Interval option.
From dropdown menu, select the Interface Start Timeout option.
From dropdown menu, select the Signal Threshold option.
All available WAN interface options are described in the table below.
Name
Type
Required
Default
Description
Health Monitor
Interval
Dropdown menu
Yes
10 sec
Interval used to
monitor Signal
strength
Health Monitor
ICMP Host(s)
Dropdown menu
No
none
Target IP address
for ICMCP
packets
Health Monitor
ICMP Timeout
Dropdown menu
Yes
3 sec
ICMP timeout
Attempts Before
WAN Failover
Dropdown menu
Yes
3
Number of fail
attempts of
Health Monitor
before interface
is torn down
Attempts Before
WAN Recovery
N/A
N/A
N/A
N/A
Priority
Number
Yes
0
Higher value is
higher priority
Minimum ifup
Interval
Dropdown menu
Yes
300 sec
Minimum interval
between two
successive
interface start
attempts
Interface Start
Timeout
Dropdown menu
Yes
40 sec
Time for interface
to startup
Signal Threshold
(dBm)
Dropdown menu
Yes
-115
if signal is lower
than this then is
marked as fail
18.3.1.3 Setting options for automatically created interfaces
From the top menu on the web interface page, select Services ->Mobile
Manager. The Mobile Manager page appears.
_______________________________________________________________________________________________________
© Virtual Access 2015
GW6600 User Manual
Issue: 2.3
Page 115 of 305