Download GGU-SLAB - Index of

Transcript
7.6.4
"Beam material" menu item
You can edit the parameters of any beams defined. A dialog box opens containing a number
of input lines dependent on the number of beam materials specified in "Boundary/Beams"
(Section 7.5.10).
The following designations apply:
 EJ = Bending stiffness of beam
 GJ = Torsion stiffness of beam
 E = Young's modulus of beam
 G = Rigidity modulus of beam = E/2 · (1 + )
 J = Moment of inertia of beam
Due to the fractured tension zone often only a fraction of the theoretical torsional stiffness GJ
(often even = 0.0) is adopted for reinforced concrete. If the values are not known they can be calculated by pressing the "Calculate" buttons.
7.6.5
"Test" menu item
The system is tested for the minimum node spacing and overlapping of triangle elements. The test
can be aborted at any time by pressing the right mouse button.
GGU-SLAB User Manual
Page 61 of 120
October 2015