Download Functional Description Manual

SYNAX
The Terminal
1-9
The list used in the example has only six programmable elements after
this step.
If the programmed length of the lis is equal to the maximum length, then
the key <STRG/E> has no effect:
21.0
22.0
Input
22.0
23.0
<STRG/L>
23.0
24.0
24.0
25.0
25.0
26.0
1.3
21.0
CLC transmits!
26.0
The structure of the parameter files
Files are produced when storing CLC parameters. The following
describes their structure.
A parameter file is made up of one or several management sections and
the data blocks (usable data). Only ASCII symbols from IBM (MS-DOS)
are used in the parameter file. Every line is concluded with <CRLF>.
Parameters file management
A management section of a parameter file is made up of five lines. Every
line must be concluded with <CRLF>.
The first line must include "SERCOS-ASCII".
The fifth line includes the drive address set on the hardware of the drive.
The drive address is made up of two symbols and must be located within
the range 01 to 99.
Lines 2, 3 and 4 (free lines) are available for use by the user. They may
have no more than a maximum of 60 symbols. If data from the CLC
controller card is stored, then the CLC will enter the symbol <*> 12 times
in the lines 3 and 4. In the line 2 the CLC writes the firmware version.
When using the free lines, the user can later program these as needed.
Structure of the management section
SERCOS-ASCII
<free line>
<free line>
<free line>
<drive address>
The CLC creates the following management section when storing the
parameter files:
DOK-SYNAX*-SY*-06VRS**-FK01-EN-P