Download TE-6.4 series Criterion Particulate Spectrometer Analyzers Manual

C r i te r i o n TE -6. 4 - Co nti n uo u s P a rt i c u l at e Mo n i t o r U s e r M an u al 1 . 0
5. Editing with AirQ From the AirQ Configuration Window the following TE‐6.4 sensor settings and parameters can be altered. Location: the instrument’s location, with AirQ the operator is always“Remote Control” Refresh Time: the TE‐6.4 storage interval. Alarms ON at: the TE‐6.4 alarm level as % of alarm range Mass Calibration: the TE‐6.4 particle calibration factors Measure TSP/Inhalable/TSP‐PM2.5: set TE‐6.4 to measure TSP/ Inhalable/TSP‐PM2.5 Measure PM10/Thoracic/PM10‐PM2.5: set TE‐6.4 to measure PM10/ Thoracic/PM10‐PM2.5 Measure PM2.5/PM2: set TE‐6.4 to measure PM2.5/PM2 Measure PM1/Respirable: set TE‐6.4 to measure PM1/Resp. Measure Wind Speed: set TE‐6.4 to record wind speed Measure Wind Heading: set TE‐6.4 to record wind direction Measure External 1: set TE‐6.4 to record the External 1 input Measure External 2: set TE‐6.4 to record the External 1 input Micrograms/mtr^3: set TE‐6.4 to measure in micrograms/mtr^3 Alarms Enabled: set the alarm to operate if dust level exceeded. Inlet Heating: set the inlet heater to be on permanently New Sample Daily: allows instrument to start a new sample each day when sampling off‐line. Auto Restart: allow instrument to restart itself when off‐line, or if communications are lost with AirQ. Note you cannot change in or out of Workplace Mode or Differential Mode using AirQ, but it will sense which mode you are in and get the appropriate descriptions from the sensor. Please refer to the AirQ online help for further information. Page 22