Download bluepoint LED User Manual

12 Warning
Overview
Overview
The operating state Warning indicates that the unit is not completely ready for use, or that
there is a problem that must be rectified.
The list of warnings below shows all the warning messages generated by the
bluepoint LED xxx, with their causes and remedies.
If the unit issues a warning that cannot be rectified by following the instructions, Dr. Hönle
AG Customer Service must be contacted. If possible, create a Device Report before doing
so; see “Send Device Report via RS232 DRPT Instruction:”, page 59.
Contact address:
Dr. Hönle AG
UV-Technology
Lochhamer Schlag 1
D-82166 Gräfelfing / Munich
Tel.: +49 (0)89 / 856 08-0
Fax: +49 (0)89 / 856 08-148
Status LED Flashing
Warning
Overview
Display
Temperature:
Temperature
fault if temperature rises any
further
1
2
3
4
:
:
:
:
Intensity:
Power indicator
flashing
1
2
3
4
:
%
: 1 0 0%
: 1 0 0%
: 1 0 0%
LED temperature
too high:
Temperature indicator flashing
1
2
3
4
:
:
:
:
wa r n i ng
i n s i d e T e mp .
1
1
1
1
0
0
0
0
0%
0%
0%
0%
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
3
3
3
3
3
3
3
3
,
,
,
,
,
,
,
,
0
0
0
0
0
0
0
0
s
s
s
s
s
s
s
s
2
2
2
2
7
6
6
6
5
5
5
5
7
1
2
4
°
°
°
°
°
°
°
°
o
o
o
o
*
*
*
*
Cause
Remedy
Temperature in the
unit is very high.
Check surrounding temperature, and
ensure better
cooling
In PeakPower mode,
the max. power cannot be set because
the LED temperature
is too high.
In ConstPower mode,
the radiation power
can no longer be held
constant because the
temperature of the
LEDs is too high.
LED temperature is
very high. Switch-off
threshold has almost
been reached.
Ensure better
cooling of the
LED, or select a
different mode
In ConstPower
mode: lower the
power setting
Ensure better
cooling of the
LED, or lower
the power setting
Note
A warning does not lead to the LED or the unit being switched off. It
may be possible – with limitations – to continue working.
# 39271c
63