Download Temperature control unit - Legrand E

03: ------------Not connected
5
51
ZONE 2
01: HEATING
0 2 : - -MENU
----------MAIN
03: -------------
Visualize Zones
H e a t i n g Mode
Programming
Setup
Maintenance
5.5.1.3 Pumps
ZONE 2
09: ------------HEAT
1
COOL
0
0
continues
ZONE 2
Zone test...
CONFIGURE ZONES
1:LIVING ROOM
2:ZONE 2
3:ZONE 3
Pumps
Press the C key to send the configuration set to the
zone.
Once the test procedure is complete, the following will be
displayed should an error be present on the zone:
ZONE 2
ERROR
Verify the
probe
configuration.
Check that any P seat on the probe has been configured (P = CEN) and try again.
The zone test screen does not appear for the local zone, because the settings are
managed directly by the Control unit.