Download 4th CONTROL SYSTEM USER MANUAL

Transcript
3.4 Layer Parameters
Layer can be taken as a kind of processing technology. A layer is equivalent to a processing
technology. There are several kinds of processing parameters in a layer.
Work power:
Set the amount of laser energy during the
processing.
Corner power:
Set the minimal (cornering) edge lining energy when
cutting.
Layer list
Layer Para
small corner power
big corner power
Fig.3-27 Corner Power effect
Work Para
Work vel:
Set the speed of cutting.
Work acc:
Set the acceleration during the processing.
Note
For more information about SmartCarve4,
please read the user manual of Hans Yueming
SmartCarve4.2.
Para Info
Fig.3-28 Layer Parameters
-29-