Download UPSTEALTH USER MANUAL
Transcript
SYSTEM DESCRIPTION & RELAY SETUP BATTERY CAPACITY TRIGGER MENU This menu allows you to control a relay based on battery capacity during a power failure. When the battery capacity drops below the set battery capacity, the relay is turned ON. The relay can be used to put the cabinet into Flash so the backup time can be increased. To Setup a Battery Capacity Trigger: Select NEXT to get to the battery capacity trigger panel, if not already on it. Battery Capacity Trigger Menu Display Select SET. The cursor will now be in the trigger pane. Press LEFT/RIGHT to move the cursor. Press UP/DOWN to change the capacity trigger point. After entering the capacity point, move the cursor to ON or OFF. Press ENTER. The save menu will appear and the cursor will move to it. Review changes and select YES. The relay is now configured. RELAY STATUS MENU Selecting “STATUS” from the Relay menu brings up the follows display: The real time status of all 8 relays is shown on this display. The “C” under the R1 relay heading indicates that Relay 1 is energized and the normal open contact is Closed. The “O” under the other relay headings indicates that the other relays are not energized and the normal open contacts are Open. Relay Status Menu Display This display shows status only and has nothing that can be changed by the user. U P S T E A LT H U S E R M A N U A L / 2 0