Download PR22 PR22 - Cytron Technologies
Transcript
ROBOT . HEAD to TOE PR22 – Reading Compass Module, Capacitive & Barometric Pressure Sensors Interface Capacitive PIC16F876A Sensor with To use the capacitive sensor, users have to solder 4 pin header pin to the sensor. Capacitive Sensor: Figure 5 Figure 5 is a 2X16 character LCD. LCD connection pin and function of each pin is shown: 3 4 VEE RS 5 R/W 6 E 7 8 9 10 11 12 13 14 15 DB0 DB1 DB2 DB3 DB4 DB5 DB6 DB7 LED+ 16 LED- Pin function Ground Positive supply for LCD Brightness adjust Select register, select instruction or data register Select read or write Start data read or write Data bus pin Data bus pin Data bus pin Data bus pin Data bus pin Data bus pin Data bus pin Data bus pin Backlight positive input Backlight negative input R6 Res1 1K R7 Res1 1K RC1 RC0 GND RA5 Figure 7 RB0 RB1 RB2 RB3 RB4 RB5 RB6 RB7 RC2 3.3V RC4 RC3 GND 3.3 SDA SCL AD7746 GND Figure 8 RC2 Interface Compass PIC16F876A Module with To use the compass module, users have to solder 4 pin header pin to the module. Compass Module: Vss Vcc Vee RS R/W E DB0 DB1 DB2 DB3 DB4 DB5 DB6 DB7 LED+ LED- 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 RA5 RB0 RB1 RB2 RB3 RB4 RB5 VCC RC1 RC0 Connection GND 5V The capacitive sensor needs a 3.3V supply to operate. The RC4 and RC3 pins are SDA pin and SCL pin of PIC16F876A which require pull-up resistors. Refer to I2C interface of PIC16F876A (3.3V) section. RB6 RB7 Name VSS VCC SCL SDA 3.3 GND Pin 1 2 LCD DISPLAY GND 3.3 SDA SCL LCD Figure 6 Figure 9 Created by Cytron Technologies Sdn. Bhd. – All Rights Reserved 4