Download Sanimixer 3000
Transcript
Sanimixer 3000® 5.4.3.2 1. 2. 3. 4. 5. 6. Installation and mounting of Impeller Monitor Fasten the holder onto the flange. Mount the drive unit to the vessel. Do not install the sensor until the drive unit is installed as the sensor can be accidentally damaged due to rough handling. Screw the magnetic sensor into the holder and through the lock nut as per figure below. Tighten the sensor until it touches the vessel. Loosen the sensor one or two turns, having no longer contact with the vessel. Lock the sensor in place with the nut. As the holder is threaded, a single nut is enough to lock the sensor in position. Connect the electrical socket to the sensor.