Download Simon 3 - Protectron Security Systems

Use the Table in Appendix B, which was filled out during the system planning, to help
program sensors.
Note
For a more specific location
name, press Option # for
compass directions (north,
northeast, east, southeast,
south, southwest, west,
northwest).
Note
If you wish to use a sensor
number other than the next
one available, use the numbered keys to enter a 2 digit
sensor number immediately
after entering the sensor
type.
¾To add a hardwire or RF sensor or remote control:
1. Press Add. The panel announces “Select from Main Menu.”
2. Press Sensor/Remote. The panel announces “Press button on sensor.”
3. Press the sensor program button or release sensor tamper switch. The panel
announces “Keychain Remote. Press sensor again for next name or press Done to
select.”
4.
5.
6.
7.
Press Sensor/Remote repeatedly until you hear the name or item you want to use.
An alphabetical list of names the panel uses appears in Appendix B. Each name
may be used more than once.
Press DONE when you hear the desired name. The panel announces “Use numbered keys to enter sensor group.”
Enter the 2-digit sensor group. The panel announces the sensor group and the first
available sensor number, then prompts you to press DONE to accept.
Press DONE. The panel confirms programming by announcing the sensor number, name, and group.
Version 3
START MENU
Cancel
Delete
Add
Test
System should be checked
by a qualified technician
at least every three years.
* Press for program
Light
Control
*
*
MAIN MENU
Sensor/ Access
Code
Remote
*
4
Clock
Set
*
0
1
Entry/Exit CONTROL MENU
Time
Delay
Sensors
Unit #
Instruction
Summary
Option #
*
5
2
3
7
-
Minutes
8
9
To delete an option or access code
Delete
Panel Beeps
Panel Voice
DONE
Latchkey Time
Sensor Activated Light Lockout Start Time
Sensor Activated Light Lockout Stop Time
Chime Voice
Speaker Volume
Pager Phone Number
Status Beep Volume
Add
Press
Hold key or press
repeatedly until you
hear the desired item.
Delete
+
Add Option
Option #1:
Option #2:
Option #3:
Option #36:
Option #37:
Option #41:
Option #42:
Option #43:
Option #55:
Note:
- Hours +
*
6
422-2806 Rev A
information.
press
and follow the voice
prompting.
Add Access Code
See Note
, then
See Note
If you make a mistake or want to
Cancel
use red numbers to enter 4-digit code.
start over press
Set Clock
Sensor or Phone Test
Option #
and follow voice prompts.
Cancel
Add Access Code DONE
Press
Clock Set Hours
Minutes
Press
See Note
DONE
Test
To select a test, press
and
follow the voice prompting.
¾To delete sensors:
1. Press Delete. The panel announces “Select from Main Menu.”
2. Press Sensor/Remote repeatedly until you hear the name and number you want
deleted, then press DONE. The panel announces that the sensor is deleted.
X10 Module Operation
Use the following procedure to program X10 module operations into panel memory.
Notice that the Light Control button is used to program all X10 module operations
(light, appliance, and universal).
¾To program the house code:
1. Press Add.
2. Press Light Control repeatedly until you hear the desired house code letter.
3. Press DONE.
Simon Security System
18