Download here - jj-ccr

www.JJ-CCR.com
4.12 Soda lime canister (radial)
This section explains the radial soda lime canister available as an option
to the JJ-CCR.
•The radial soda lime canister must be filled extremely carefully and it isessential to ensure that the soda lime is correctly compacted.
•In order to fill the radial soda lime canister correctly, take a minimum of
10 minutes for this action.
A water-resistant dust filter is located on the inner tube. This prevents dust
from the soda lime from entering the inhalation side of the breathing circuit.
In order to replace the dust filter it is possible to simply screw out the entire
inner tube. The dust filter is attached by three O-rings.
The radial soda lime canister must be filled in stages. At each stage, approx. 5 – 7 cm of soda lime should
be added. Each time soda lime is added this must then be compacted. This is most simply carried out by
knocking right around the edge of the black section of the soda lime canister. Fill the soda lime canister
until you can see clearance of 4-5mm. Knock lightly all around the black section of the canister, in order
to level out the soda lime or compact it.
Never knock on the top section (= grate) of the
soda lime canister in order to compact the sodalime. This could damage the soda lime canister.
IMPORTANT: Soda lime that has already been
used must never be used for another dive.
Insert the spring pressure plate and tighten the nut until it is hand-tight. Then knock lightly all around the
black section of the canister, in order to level out the soda lime or compact it. The nut will usually loosen
a little during this process and must be hand tightened again afterwards. The pressure plate must be flush
with the soda lime canister. The soda lime canister is correctly filled if shaking it does not result in noise
being heard from the soda lime.
2014 JJ-CCR ApS – Version 2.00 / Revision 04
JJ- CCR ApS 2014
22