Download Traqmate User Manual

Traqmate User Manual V3.15
May 17, 2010
TraqCam cables have been discontinued in favor of the more robust and capable TraqSync
interface but the connection method is shown here in support of legacy users. For a TraqTach,
use the ALT connection point and for the TraqData use the D4 connection point
to Traqmate
Sensor Unit
TraqTach or
TraqData
ChaseCam
PDR100
RJ11 Plug
Green
on
GND
D4 or D5 on TraqData
ALT on TraqTach
TraqCam Cable
Figure 72 - TraqCam Cable to ChaseCam PDR100
After making the physical connections, you must set up a digital output on the Traqmate using
Traqview as shown below. This is the default for Traqmates released after V2.10. Note that you
do not have to check ‘Input Enable’ if you do not have any digital inputs. This will maximize
recording time.
Figure 73 - Enabling ChaseCam PDR100 Control
Copyright © 2005 - 2010 Track Systems Technologies, LLC
Page 93