1
Download CTL004 The Chasing Controller User Manual
Transcript
Lighting LED TECHNOLOGY CTL004 The Chasing Controller User Manual I. Controller Parameters: on Voltage: DC12V on Current: <60mA on Temperature: -20 C – 60 C Size: L100*W70*H25 mm Effect Mode: 114 different types of mode designs Max Control Points: 1024 Points Remote to controller distance: ~ 15 meters II. The Chasing Controller Diagram: III. Key Func n: a. On/Off: turn on / turn off b. -: Mode- / Speedc. +: Mode+ / Speed+ ng. d. Mode/Speed: on the display, ”H” means Mode s ng, “S” means Speed How to use the chasing controller: Plug in DC12V power supply a. How to set up points 1. Press On/Off bu on to turn Off, make sure nothing shows on the display. 2. Hold Mode/Speed bu on for 3 seconds, then ‘’H-50” will appear on the display, a erwards, press + or - u you found your desired distance. (see Note:) 3. Press Mode/Speed to save your se ngs. IV. l Note: / “Points” means: strip length/ 10 points per meter/ er point ng, the controller will save automa cally, there is no need to reset your se ngs again next me. (If you want reset your se ngs, return to step 1.) b. How to use the Mode/Speed b on 1. Mode Usage: Press Mode/Speed bu on; find “H” on the display, then press – or + b on to find your preferred design from 114 different types of mode designs. (For the whole mode list, check page 2-4 on the manual.) 2. Speed Usage: Press “Mode/Speed” on; find “S” on the display, then press – or + bu on to find your desired speed. c. Turning off the controller 1. 2. Temporary turn off- Press the on/off bu on on the controller. e turn off- Take out the connected power supply. Overnight/ long Page 4-1 number number number 77 C - - - cyan Mo - - - - - Page 4-2 bo -Colorful - - - Colo - - Page 4-3 - - Page 4-4
