Download IDEC Manual
Transcript
Programming IDEC SmartRelay 3.6.8 Deleting a block Let us assume you want to delete the block B2 from your circuit program and connect B1 directly to Q1. B1 B2 I1 I2 x x Par Q1 Proceed as follows: 1. Switch IDEC SmartRelay to programming mode (as a reminder, refer to Page 60). 2. Select ’Edit’: Press or 3. Confirm ’Edit’: Press OK (If required, enter your password and confirm with OK.) 4. Select ’Edit Prg’: Press or 5. Confirm ’Edit Prg’: Press OK 6. Move the cursor to B2, the input of Q1 Press : B2 Q1 7. Confirm with OK. 8. Now replace block B2 with block B1 at output Q1. The procedure: - Select the BN list: Press or - Accept the BN list: Press OK - Select ’B1’: Press or - Apply ’B1’: Press OK Result: Block B2 is deleted, because it is no longer used in the circuit. Block B1 has replaced B2 directly at the output. IDEC SmartRelay Manual 83
Related documents
B-1090(5) - Idec Elektrotechnik GmbH
IDEC FL1E Series Smart Relays
FL1E Series User`s Manual - Clearwater Technologies Inc.
IDEC SmartRelay – The Intelligent Choice
Configuring IDEC SmartRelay
IDEC Smart Relays Brochure
Product Announcement
FL1E Series User`s Manual Supplement
6th-Generation IDEC SmartRelay
H IDEC SmartRelay
SIMATIC LOGO! Manual - Service, Support
IDEC SmartRelay Series Manual