1
Download Netiom Manual in PDF Format
Transcript
Relay Module The Relay module consists of 8 single pole change over relays which can be connected directly on to the Netiom controller. Connection is via a ribbon cable to the output header. If all 16 outputs are to be used then two Relay modules will be required. Internal Elements Counters Each input has associated with it a 16 bit counter. Each time the input goes high the counter is incremented. At power up all counters are set to zero. The counters can be reset individually or collectively using a command from a browser or from a Client connection. Latches Each input has two latches, a high latch and a low latch. The high latch is set when the input goes high and the low latch is set when the input goes low. The latches can be reset individually or collectively using a command from a browser or from a Client connection.
