Download User Manual - IRT Communications

Transcript
IRT Eurocard
Type DVG-4090
SDI / Composite Test Pattern Generator
with Crash Switching
Instruction Book
Table of Contents
Section
Page
Operational Safety
General Description
Technical Specifications
Configuration
Link Settings
Front Panel Indicators
Front Panel Switch Controls
Test Patterns
Installation
Rear Assembly
Alarm Output Connection
Front & rear panel connector diagrams
Operation
SDI Input
Analogue Composite Input
Front Panel Indicators
Mode setting
Examples of Mode setting outputs
Banner Setting
Test Pattern Setting
Programming via USB interface
Downloading of Banners and Pictures
Setting of Audio Frequencies and Amplitudes
Countdown Banner
SNMP
DVG-4090 SNMP Functions (Future)
Maintenance & storage
Equipment return
2
3
4
5
5
5
5
7
17
17
17
18
19
19
19
19
19
20
21
21
22
23
24
24
26
28
29
29
This instruction book applies to units later than S/N 0710001.
Operational Safety:
WARNING
Operation of electronic equipment involves the use of voltages and currents that
may be dangerous to human life. Note that under certain conditions dangerous
potentials may exist in some circuits when power controls are in the OFF
position.
Maintenance personnel should observe all safety regulations.
Do not make any adjustments inside equipment with power ON unless proper
precautions are observed. All internal adjustments should only be made by
suitably qualified personnel. All operational adjustments are available externally
without the need for removing covers or use of extender cards.
4090-dvg.ib.rev1.doc
2 of 29
22/10/2007