Download FULL-POTENTIAL PROGRAM PACKAGE"LMTART" USER`s MANUAL

Transcript
scf+hbr keywords. This will tell the program to create HBRFILE which is the output ¯le
containing LDA+U information. There are many more ¯les which can be withdrawn after the
calculation: BNDFILE (extension .bnd) stores energy bands calculated at a set within a tetrahedron grid; FATFILE (extension .fat) stores energy bands and wave function characters which
can be plotted as "fat bands" along high{symmetry directions; DOSFILE (extension .dos) stores
density of states ¯le; POTFILE (extension .pot) stores full potential; PSIFILE (extension .psi)
stores wave functions, etc. As an example of RUNMODE producing energy bands, and density
of states one types: bnd+dos. If one does not specify out here, the output will be written to
the terminal. There is some incompatibility in requiring to produce FATFILE and other ¯les
since FATFILE requires the k{grid to be produced along high{symmetry directions while other
¯les require the k{grid produced using tetrahedra. It is therefore not possible to type dos+fat
or bnd+fat, the program will stop in this case. That is one limitation in combining di®erent
output ¯les which has to be kept in mind. Another limitation is that it is assumed that one
should ¯rst do the self{consistency and, second, calculate di®erent properties as energy bands,
densities of states or wave functions. It is therefore advised not to use such combinations as
scf+dos, scf+bnd, etc
An alternative way to set up RUNMODE line is to type the following keywords which will be
interpreted as a certain combination of the ¯les:
KEYWORD1
KEYWORD2
Prepare for SCF
con
Self{consistency
con+scf+out
Fat Bands
fat
Density of States
dos
Energy Bands
bnd
Wave Functions
psi
Full Potential
pot
Custom
+++
There is one more option provided to set{up the running mode. This can be done by editing
the corresponding lines in the INIFILE and will be discussed in the next Section. If this is so, set
RUNMODE to Custom or +++.
10