Download HM207.03a rel. 2 (English version)

HM 207.03A
[ MY XXX @
Number of alphanumerical table to
transmit to PC
A=Opening of an alphanumerical table
Writing operations in PC memory:
[ XXX XXXXX ... @
Alphanumerical code transmitted
(CRS IDEA 1 ...)
Address of the alphanumerical table
transmitted
[ MY XXX @
Number of the table to close
C=Closing table transmission
Command code letter "S":
Writing operations in instrument memory:
{ XX SY XXX ... @
{ 0 1 S V 1 2 3 . 5 @
Numerical
series
transmitted
(123,5345,7)
V=Successive characters are not an
address but a series of numbers. The
letter (any) identifies the variable
transmitted
{ XX SY @
Value of set-point
Speed
write
command code
{ 0 1 S ? @
?=Request from PC to instrument to
read the numerical series. The
instrument will transmit all the
variables
Write operations in PC memory:
[ Y XXXXX ... @
Request for transmission of the variables present
in the instrument (set-point and speed)
[ S 1 2 3 . 5 @
Numerical
series transmitted
(123,5345,7). Max. 32 characters
Value transmitted( set-point
or processor variable)
V=
The letter identifies the variable
transmitted
S= Set-point
U=Speed
variable)
(processor
Pag. 20 of 24