Download User Manual - Gill Instruments

R3-50
Doc. No. 1210-PS-0011 Issue 04
February 2005
_______________________________________________________________________________________________________
4. Options
Gill Instruments Ltd
1. Output Field Separator
COMMA
2. Output Line Terminator
CR/LF
3. Download Format
ASCII
4. Display Maxima and Minima
On
5. Output Period
0
6. Return to Main Menu
6.19 Storage of settings
All menu selections that set a parameter are stored in a data file on the hard disk in a file
named “\RCOM\MICROMET.SET”. This prevents the users from having to re-enter
settings each time the program is run. If this file cannot be found then default values will
be used and the file created.
6.20 RCOM Error Messages
Transducer pair(s) X failed
One or more transducer pairs (indicated by X) has failed. This may be due to failure of
one or both transducers or their associated electronics, or due to a blockage in the
ultrasonic path.
Non-volatile memory error
Indicates a failure in the non-volatile EEPROM memory of the anemometer.
Absolute PRT failed
Indicates failure of the PRT temperature probe or its associated electronics
Configuration Mis-match
Indicates that the configuration reported by the status codes in Measurement Mode does
not match that reported by the CONFIG command in Interactive Mode.
Anemometer Type Mis-match
Indicates that the anemometer type reported by the status codes does not match the
anemometer type indicated by the serial number.
Transducer pair(s) X at n% gain
Indicates that one or more transducer pairs (indicated by X) is at a high gain setting (50,
90 or 100%, indicated by n).
___________________________________________________________________________________________
Page 17