Download PNI Corporation - Tri

factory
(Factory Settings)
Description Resets the TCM2.5/2.6 to the factory settings. The internal modes are set to the
following factory defaults
b=5
er=e
mpcal=d
cc
et=d
sdo=t
damping=d
timeconst=8
sn=m
ec=e
halt=d
sp=8
em=d
ma=u
uc=d
ep=e
mag_dec=0.0
ui=d
Syntax
factory<cr>
Output
H0V0m0.00<cr><lf>
Example
factory<cr>
go
ut=c
(Enter Continuous Sampling Mode)
Description Enters the Continuous Sampling Mode (go). The TCM2.5/2.6 immediately begins
outputting sensors data at rate specified by the SP parameter, default is 8 Hz. Data is
automatically transmitted according to the Output Word Format (sdo=) currently
specified. To exit the TCM2.5/2.6 and return to Standby mode, issue the Halt
Continuous Sampling (h) command.
Syntax
go<cr>
Output
Selected data output word.
Example
go<cr>
Related Commands
s? (Single Update of Output Word)
h (Halt Continuous Sampling)
PNI Sensor Corporation
TCM2.5 & TCM2.6 User Manual
DOC#1009269 r11
Page 28 of 49